Ergotron WorkFit-B Guide de l'utilisateur télécharger pdf (Page 13)

13 of 18

888-24-227-G-00 rev. B • 07/13

2.5 mm

Remove the 4 brake stop screws before installing equipment.

Remove the 2 stop screws from the legs then the 2 stop screws from

the brake to allow the worksurface to raise and lower.

After you remove the 4 brake stop

screws, release the hand brake

(on the right leg) and move the

worksurface up to highest level.

Set-up Steps

IMPORTANT!

Save these stop screws and instructions. Install stop

screws when shipping or storing this product. Failure

to follow these instructions may cause lift engine to

expand rapidly and may result in equipment damage

and or personal injury.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Pas de commentaire

Ergotron WorkFit-B Guide de l'utilisateur Page 13